Chroma coat

Description: Chroma coat is formulated to be mixed with cement on site or simply brush applied over concrete or masonry surfaces to provide an effective waterproof membrane.

Technical support: Chroma provides a technical advisory service supported by a team of specialists in the field. .

Areas of Application

Areas of Application

Preparation: All surfaces to be treated with Chroma coat must be thor- oughly cleaned by a wire brush or other mechanical means, to remove all dust, laitence or debris. The surface must also be free from oil, grease, wax or any other form of foreign matter which might affect adhesion. Spalled and deeply disintegrated concrete or mortar must be removed to a sound substrate and repaired suitably before coating.

Topcoat: Chroma coat acrylic polymer shall be mixed with neat cement in the ratio of 1:2 respectively, to obtain a uniform and consistent slurry avoiding any lump formation. This can be achieved with a low duty, low speed drilling machine attached with a mixing paddle. Do not mix for more than 2 minutes. Do not mix more material than which can be used within the pot life. Retempering the mix with water should not be done. occasionally stir the material till the entire quantity is applied, so that solids do not settle at the bottom of the container.

For white colour - mix white cement, for other colours, add cement compatible pigments to white cement. .

Application For best results, wet the surface before coating. Apply the mix with a short, stiff bristle brush like a paint to an approximate thickness of 1 to 2mm. During the first 12 hours of curing, Chroma coat surface must be protected from abrasion, rain or other adverse conditions. No traffic shall be allowed within 48 hours after application.

Normally 2 coats of application of Chroma coat are recommended. First coat should be allowed to air dry for 5 - 6 hours. After application of the final coat, initial air drying shall be allowed for 2 to 6 hours. During this period water should not be used for curing. Moist curing should be done for the next 24 hours by spraying water on Chroma coat coating. Following moist curing, Chroma coat should be allowed to dry for three days before subjecting it to submersion in water.

Estimating:

Packaging Available in 1, 5 & 20 L packs.

Coverage Priming coat - 16-17m2 / L.
Topcoat - 4.5 - 5.0m2 / L / coat.
However the practical consumption varies depending on the texture and porosity of the surface and the application thickness.

Storage Chroma coat liquid has a shelf life of 12 months,when stored in unopened containers under normal warehouse conditions.

Fire Chroma coat is nonflammable.

Chroma Coat (TDS)-C is a high-quality coating offering vibrant color retention, durability, and excellent resistance to weathering and abrasion. Ideal for industrial and commercial surfaces, it provides a long-lasting, protective finish with a high-gloss appearance. Review the technical data sheet (TDS) for complete application details and performance characteristics. Mumbai, Maharashtra, India